When A Warning Message Occurs - SATO s84ex Operator's Manual

a

6.2 When a Warning Message Occurs

When a warning message is shown on the screen, the printer continues issuing media.
The warning message, its cause and the countermeasures are as follows:
Warning
No. Message
Label near end
01
Ribbon near end
02
Receive buffer
nearly full
03
Command error
04
Head error
05
LED/Buzzer
Lights blue. The remaining amount of
media is not enough.
No beep.
To clear the error:
Open and close the
print head.
Lights blue. The remaining amount of
ribbon is not enough.
No beep.
To clear the error:
Open and close the
print head.
Lights blue. Available space for
receive buffer is low.
No beep.
Lights blue. Command error has been
detected.
One short beep.
To clear the error:
The icon will be
cleared by receiving
the next item or
canceling the job.
Lights blue. A head check error is
detected when
No beep. "NORMAL" has been
selected for the HEAD
CHECK setting screen.
Change the HEAD
CHECK setting to
"BARCODE" and continue
the print job.
Cause Countermeasure
Replace the media.
Refer to
Loading Media
details.
Replace the ribbon.
Refer to
Loading the Ribbon
details.
Do not send data from the
host until the analysis of
received data is
completed.
Check the print data.
Replace the print head.
Refer to
Replacing the Print
Head for details.
S84-ex/S86-ex Operator Manual
6 Troubleshooting
Section 3.5
for
Section 3.2
for
Section 7.7.1
231