CAB EOS1 Operator's Manual page 32

32 8 Fault Correction
Error message
Protocol
error
Read error
Structural
err.
System Error
Unknown card
USB error
Write error
Write
protected
Table 5
Cause
Printer has received an
unknown or invalid command
from the computer, e.g.
the command to perform a
cut although a cutter is not
mounted
Read error when reading
from the data medium.
Error in the file list of the
data medium, data access is
uncertain.
e.g. FPGA defective, invalid
setup, voltage error
Data medium not formatted.
Type of data medium not
supported.
e.g. Too much current, no
reaction, unknown device
Hardware error
Data medium write protection
is activated.
Error Messages and Fault Correction
Remedy
Select Continue to skip the
command or
select Cancel to cancel the print
job.
Check data medium.
Backup data, reformat medium.
Format data medium.
Switch the printer off and then
on. Please note error details
shown on the display.
If error recurs call service.
Format data medium.
Use different type of data
medium.
Do not use the USB device.
Repeat the write process,
reformat card.
Deactivate the write protection.
33 32