CAB EOS1 Operator's Manual page 31

8 Fault Correction
Error message
Memory
overflow
Name exists
Network
Error
No label
found
No label
size
Out of paper
Out of
ribbon
Cause
Current print job contains
too much information, e.g.
selected font, large graphics
Duplicate usage of field name
in the direct programming
e.g. No DHCP server, no
link, no SMTP server, no
Timeserver
There are labels missing on
the label material
The label format as set in the
software does not correspond
with the real label format
Printer is loaded with
continuous paper, but the
software is set on labels
The size of the label is not
defined in the programming.
Out of label roll
Error in the paper feed,
Material is not positioned
under the label sensor.
Out of transfer ribbon
Transfer ribbon melted during
printing
The printer is loaded with
thermal labels, but the
software is set to transfer
printing
Remedy
Cancel current print job.
Reduce amount of data to be
printed.
Correct programming
Please contact your network
administrator.
Press Continue repeatedly until
printer recognizes the next label
on the material.
Cancel current print job.
Change the label format set in
the software.
Restart print job.
Cancel current print job.
Change the label format set in
the software.
Restart the print job.
Check programming.
Load labels.
Check paper feed.
Insert new transfer ribbon.
Cancel current print job.
Change the heat level via
software.
Clean the printhead  7.2 on
page 23
Load transfer ribbon
Restart print job.
Cancel current print job.
Set software to direct thermal
printing.
Restart print job.
31