Lights - Arctic Cat CFR 800 2010 Operator's Manual

! WARNING
Do not adjust the front arm limiter
straps to a point at which steering
and operator control of the snow-
mobile are adversely affected.
Adjusting Rear Spring
Pre-Load
Proper adjustment of rear spring pre-
load is necessary to get the most com-
fortable ride. The chart is designed to
help in setting up rear spring pre-load;
however, riding style is the single
greatest factor in determining rear
spring requirements.
Rider Weight (lb)
Up to 180
180-240
Over 240
 NOTE: These cam position set-
tings are suggestions only. Per-
sonal riding style will greatly
influence cam position settings.
Spend time to determine setting
preferences.
Rear spring pre-load adjustment is
accomplished by rotating the adjusting
cams. Position 3 provides the stiffest
ride, and position 1 is for the light
driver or slow-speed trail riding. Posi-
tion 2 is for the average operator under
normal conditions. Always rotate the
cam from the lighter position to the
heavier position.
CAUTION
Never force the adjustment cams
from the low position to the high
position. Cam damage may occur.
66
Cam Position
1
2
3
To rotate an adjusting cam, use the
spark plug wrench from the tool kit.
Rotate the wrench until the cam is in
the desired position. To stiffen the ride,
rotate the cam so as to raise the spring
end. Make the appropriate adjustment
on the other cam.

LIGHTS

For the correct headlight bulb and/or
taillight/brakelight LED, see the appro-
priate specifications sheet.
Removing and
Installing Taillight/
Brakelight
These models are equipped with an
LED taillight/brakelight. If the LED
fails, it must be replaced. To remove
and install the LED, use the following
procedure.
 NOTE: To access the harness
connector and the two self-tapping
screws securing the taillight to the
snowflap, compress
flanged tabs (located on the under-
side of the tunnel) and carefully
pry up on the front of the taillight/
snowflap.
741-450A
the two
0744-462
MAINTENANCE