Coolant Level - Arctic Cat CFR 800 2010 Operator's Manual

 NOTE: When air can no longer
be heard purging from oil pump
bleed, tighten the bleed bolt to 7.5
ft-lb.
CAUTION
Do not attempt to start the engine
with the bleed bolt open.
12. Without starting the engine, place
the handlebar emergency stop
switch to the RUN position and
the ignition switch to the ON posi-
tion. The Oil Pressure Warning
Icon should illuminate.
 NOTE: If the warning icon does
not illuminate, take the snowmo-
bile to an authorized Arctic Cat
Snowmobile dealer for service. If
not under warranty, this service is
at the discretion and expense of
the snowmobile owner.
13. If the warning icon illuminates
(from step 12), start the engine.
The warning icon should go out
within five seconds. If it does, pro-
ceed to step 14.
 NOTE: If the warning icon does
not go out, shut the engine off
immediately and repeat step 11;
then place the ignition switch to the
ON position and repeat step 13. If
the warning icon does not go out,
take the snowmobile to an autho-
rized Arctic Cat Snowmobile dealer
for service. If not under warranty,
this service is at the discretion and
expense of the snowmobile owner.
44
14. Shut the engine off and pour the
remaining amount (0.9 l or 1 U.S.
qt) of recommended oil into the oil
reservoir; then proceed to the
Checking Engine Oil Level sub-
section to verify and finalize the
procedure.

COOLANT LEVEL

 NOTE: Use a good quality, ethyl-
ZJ004A
ene glycol-based, automotive-type
coolant.
CFR /F5/F6 Sno Pro/F8
Models
 NOTE: Always check the coolant
level with the engine cold.
Locate the appropriate FULL mark on
the coolant reservoir. If coolant is
below the FULL mark, add coolant to
the FULL mark.
On the F-Series models if adding cool-
ant, the console must be removed. For
removing/installing the console, use
the following procedure.
1. Remove the two torx-head screws
securing the console to the chassis;
then lift up the rearward end of the
console and disconnect the console
harness plug-in.
2. Remove the console.
3. Place the console into position on
the headlight support bracket; then
connect the console harness con-
nector.
0743-777
MAINTENANCE