Speedometer/Tachometer - Arctic Cat CFR 800 2010 Operator's Manual

SPEEDOMETER /
TACHOMETER
These snowmobiles are equipped with
two different speedometer/tachometer
styles. Determine which style your
model is equipped with and use the
appropriate following information.
Indicator Icons
(Standard Gauge)
Certain models are equipped with a
standard gauge combination speedom-
eter/tachometer. Indicator icons are
incorporated within the speedometer/
tachometer. Also incorporated into the
speedometer/tachometer is a digital
readout screen.
A. Oil Pressure/Low Oil
B. Coolant Temperature
C. Low Fuel
D. Fuel Level
E. Service
F. High Beam
G. Charging System (F-Series Z1/
Z1 Turbo Models)
RPM/MPH (kph)
By pushing the left button once, the
RPM and MPH will be displayed (one
on the readout screen and one with the
needle). By pushing the button once
again, the functions will be reversed.
GENERAL INFORMATION
By pushing the left button (with speed
being displayed) for more than two
seconds, the display will change
between standard mph or metric kph.
Release the button when desired dis-
play appears.
With RPM displayed on the readout
screen by pushing and holding the left
button, maximum RPM will be dis-
played on the readout screen. The max-
imum RPM readout will reset when the
right button is pushed (while maximum
RPM is displayed).
Odometer/Trip-Meter
(1)/Trip-Meter (2)/
Hour-Meter/Clock
 NOTE: The clock is available on
electric start models only.
By pushing the right button, the read-
out screen will display odometer, trip-
meter (1), trip-meter (2), hour-meter,
and clock. To reset the trip meter with
the trip meter displayed, push and hold
the right button until the display is
cleared. The hour-meter readout will
not reset.
FZ003C
Clock (Electric Start)
With the clock selected on the readout
screen by pushing and holding the right
button for two seconds, the option of
selecting the 12-hour or 24-hour clock
is available. Push the left button for 12-
hour display; push the right button for
24-hour display. At this point, the
hours and minutes will begin to flash.
Push the left button to change the hour
display; push the right button to change
the minute display (either tap the but-
tons for individual number display or
push and hold the buttons for rapid
number display).
 NOTE: During clock setting if
neither
pushed within a 5-second time
period, the clock-setting mode will
be exited with changes saved.
button (left, right) is
9