Ski Wear Bars - Arctic Cat CFR 800 2010 Operator's Manual

5. Install the two torx-head screws
located to the outside of the head-
light adjustment
tighten securely.
6. Check headlight aim (see Adjusting
Headlight Aim in this sub-section).
! WARNING
Do not operate the snowmobile
unless headlight beam is adjusted
properly. An incorrectly adjusted
beam will not provide the operator
the optimum amount of light.
Adjusting Headlight
Aim
The headlight can be adjusted for verti-
cal aim of the HIGH/LOW beam. The
geometric center of HIGH beam zone
is to be used for vertical aiming.
1. Position the snowmobile on a level
floor so the headlight is approxi-
mately 8 m (25 ft) from an aiming
surface (wall or similar surface).
 NOTE: There should be an "aver-
age" operating load on the snow-
mobile when adjusting headlight
aim.
2. Measure the distance from the
floor to midpoint of the headlight.
3. Using the measurement obtained
in step 2, make a horizontal mark
on the aiming surface.
4. Make a vertical mark which inter-
sects the horizontal mark on the
aiming surface directly in front of
the headlight.
5. Engage the brake lever lock and
start the engine. Move the head-
light dimmer switch to the HIGH
beam position. DO NOT USE
LOW BEAM.
MAINTENANCE
knobs; then

SKI WEAR BARS

The ski wear bar is a replaceable bar
attached to the underside of the ski.
The purpose of the wear bar is to assist
in turning the snowmobile, to minimize
ski wear, and to maintain good steering
control. If the snowmobile is operated
primarily in deep snow, ski wear bar
wear will be minimal; however, if the
snowmobile is operated on terrain
where the snow cover is minimal, the
ski wear bar will wear faster. To main-
tain positive steering characteristics,
Arctic Cat recommends that the ski
wear bars be checked before each use
and replaced if worn beyond 1/2 of the
original diameter. Ski wear bars are
available from an authorized Arctic Cat
Snowmobile dealer.
6. Observe the headlight beam aim.
Proper aim is when the most
intense beam is centered on the
vertical mark 5 cm (2 in.) below
the horizontal mark on the aiming
surface.
7. Adjust the headlight using the
adjustment knobs until correct aim
is obtained. Shut the engine off;
then disengage the brake lever
lock.
! WARNING
Operating the snowmobile with
excessively worn ski wear bars
may result in a loss of steering
control.
0741-448
69