Fuses; Hydraulic Brake System - Arctic Cat CFR 800 2010 Operator's Manual

FUSES

Fuses protect the snowmobile electrical
system from overloading. If electrical
parts in the snowmobile are not work-
ing, the system may have been over-
loaded and caused a blown fuse.
Before repairing or replacing any elec-
trical part, check the appropriate fuses.
If a fuse blows (opens a circuit), all the
parts of the snowmobile that use that
circuit will not work.
Once which fuse to check has been
determined, perform the following
steps:
1. Open the right-side access panel;
then on the F-Series Z1/Z1 Turbo
models, remove the fuse panel
cover (the fuse panel is located
behind the battery). On the CFR/F-
Series models, disconnect the fuse
connector harness.
F-Series Z1/
Z1 Turbo
Models
CFR/2-Stroke F-Series
Models
 NOTE: On the F-Series Z1/Z1
Turbo models, there are spare
fuses inside the fuse panel.
MAINTENANCE
2. Remove the suspected fuse.
3. Look through the clear side of the
fuse to see if the metal wire inside is
separated. If it is, the fuse is blown
and should be replaced with a fuse
of the correct amperage rating.
! WARNING
Always replace a fuse with one
having the same specified amper-
age rating. Using a fuse with a
higher rating can cause severe
wire damage and could start a fire.
4. Install the fuse panel cover.
Even after replacing a fuse, it may con-
tinue to blow if the cause of the over-
load is not determined. If the fuse
continues to blow, take the snowmobile
to an authorized Arctic Cat Snowmo-
bile dealer for service. If not under
warranty, this service is at the discre-
IO001A
tion and expense of the snowmobile
owner.
HYDRAULIC BRAKE
SYSTEM
Arctic Cat recommends that the brake
system (brake lever, fluid reservoir,
hose, caliper, pads, and brake disc) be
checked daily for fluid leakage, wear,
ZJ306A
or damage and for proper operation.
Also, the brake fluid level must be
checked every time before starting the
engine. The brake fluid must be visible
in the sight glass.
IO002A
55