Arctic Cat CFR 800 2010 Operator's Manual page 16

 NOTE: When air can no longer
be heard purging from oil pump
bleed, tighten the bleed bolt to 7.5
ft-lb.
CAUTION
Do not attempt to start the engine
with the bleed bolt open.
3. Start the engine. The warning light
should go out within five seconds.
4. If the warning light does not go
out, shut the engine off immedi-
ately and repeat step 2; then repeat
step 3.
If the warning light does not go out or
if the engine does not start, take the
snowmobile to an authorized Arctic
Cat Snowmobile dealer. If not under
warranty, this service is at the discre-
tion and expense of the snowmobile
owner.
Indicator Icons
(Deluxe Gauge)
Certain models are equipped with a
deluxe gauge combination speedome-
ter/tachometer. Indicator icons are
incorporated within the speedometer/
tachometer. Also incorporated into the
speedometer/tachometer is a digital
readout screen.
A. High Beam
B. Oil Pressure/Low Oil
C. Coolant Temperature
D. Increment Button
12
E. Select Button
F. Decrement Button
G. Service
H. Charging System (F-Series Z1/
Z1 Turbo Models)
RPM/MPH (kph)
By pushing the increment button once,
the RPM and MPH will be displayed
(one on the readout screen and one
with the needle). By pushing the button
once again, the functions will be
reversed.
By pushing the increment button (with
speed being displayed) for more than
two seconds, the display will change
between standard mph or metric kph.
With RPM displayed on the readout
screen by pushing and holding the
increment button, maximum RPM will
be displayed on the readout screen. The
maximum RPM readout will reset
when the decrement button is pushed
(while maximum RPM is displayed).
Odometer/Trip-Meter
(1)/Trip-Meter (2)/
Hour-Meter
By pushing the decrement button, the
readout screen will display odometer,
trip-meter (1), trip-meter (2), and hour-
meter. To reset the trip meter with the
trip meter displayed, push and hold the
decrement button until the display is
cleared. The hour-meter readout will
not reset.
Clock/Altimeter
By pushing the select button, the read-
out screen will display clock, altimeter,
FZ001A
and maximum altimeter.
GENERAL INFORMATION