Using Rs-232 Interface To Setup Ethernet Interface - Wasp WPL304 User Manual

WPL 304 User Manual

3.6.2 Using RS-232 interface to setup Ethernet interface

1. Connect the computer and the printer with a RS-232 cable.
2. Turn on the printer power.
3. Start the Diagnostic Utility by double clicks on the
Note: This utility works with printer firmware V6.00 and later versions.
4. Select
baud rate, parity check, data bits, stop bit and flow control parameters.
5. Click on the
to setup the IP address, subnet mask and the gateway for the on board Ethernet.
COM as interface then click on the
" "
Ethernet Setup
" "
Setup button to setup the serial port
" "
button from printer function of Printer Configuration tab
21
icon.