External Label Roll Mount Installation (Option) - Wasp WPL304 User Manual

WPL 304 User Manual

3.4.2 External Label Roll Mount Installation (Option)

1. Attach an external paper roll mount on the bottom of the printer.
2. Insert a 3
paper roll mount.
3. Open the printer
media width.
4. Press down the media holder lock switch to fix the media holder.
5. Feeds the media through the rear external label entrance chute. And place the
paper, printing side face up, through the media sensor and place the label
leading edge onto the platen roller.
6. Move the media guides to fit the label width by turning the guide adjuster
knob.
7. Disengage the top cover support and close the top cover gently.
8. Use "Diagnostic Tool" to set the media sensor type and calibrate the selected
sensor. (Start the "Diagnostic tool" - Select the "Printer Configuration" tab -
Click the "Calibrate Sensor" button) Please refer to the diagnostic utility quick
start guide for more information.
Note: Please calibrate the gap/black mark sensor when changing media.
label spindle into a paper roll. And install it on the external
"
s top cover and separate the media holders to fit the
'
15