Printer Initialisation - LabelStation Pro200 series User Manual

• Reset the printer by turning the POWER switch off and on.
3.1.5. Printer Initialization
Printer initialization is used to clear DRAM and restore printer settings to defaults. The only one
exception is ribbon sensitivity, which will not be restored to default.
Printer initialization is activated by the following procedures.
1. Turn off printer power.
2. Press the FEED button and then turn on power. The LED will become red, orange, green
with 5 blinking (around 5 seconds) for each colour.
3. Release the FEED button when LED becomes green (within the 5 flashes)
The LED color will be changed as following pattern:
Orange Red (5 flashes)
Printer configuration will be restore to defaults as below after initialization.
Parameter
Speed
Density
Label Width
Label Height
Sensor Type
Gap Setting
Print Direction
Reference Point
Offset
Tear Mode
Peel off Mode
Cutter Mode
Serial Port Settings
Code Page
Country Code
Clear Flash Memory
Note: When printer initialization is done, please calibrate the gap sensor again – see 5.1.2 Gap
Sensor Calibration Utility.
Orange (5 flashes)
Default setting
127 mm/sec (5 ips)
7
4.25" (108.0 mm)
2.5" (63.4 mm)
Gap sensor
0.12" (3.0 mm)
0
0,0 (upper left corner)
0
On
Off
Off
9600 bps, none parity,
8 data bits, 1 stop bit
850
001
No
- 18 -
© Advanced Labelling Limited July 2008
Green (5 flashes)
LabelStation Pro Series Set Up Manual July 2008
Solid green