Loading Label Stock - LabelStation Pro200 series User Manual

2.3.

Loading Label Stock

• Turn off the printer and open the printer cover
If your label core is 1 inch, remove the 1.5" core adapter from the fixed tab. If label width is 4
inch wide, two fixing tabs are not required.
• Slide the label supply roll spindle through the core of a label roll and attach the fixing tabs
onto the spindle.
1.5" Core Adaptor
Printing Side
Face Up
• Open the printer's top cover by releasing the green top cover open levers located on each
side of the printer and lifting the top cover. A top cover support at the rear of the printer
will hold the printer top cover open.
•
Place the loaded label spindle onto the center of the paper roll mount.
• Feed the labels, printing side face up, through the Teflon bar and the paper guide and pass
over the platen.
• Adjust the green paper guides to slightly touch the edges of the label backing paper.
•
To close the printer top cover, lift the cover to the ultimate open angle then use both
hands to close the cover gently. Close the printer top cover slowly and make sure the cover
locks latch securely.
Fig. 7. Label Roll Installation
Fig. 8 Pull the lever to open the cover
- 10 -
© Advanced Labelling Limited July 2008
Label Roll
1" Label Spindle
Fixed Tab
LabelStation Pro Series Set Up Manual July 2008