External Label
Feed Opening
•
Feed the labels, printing side face up, through the paper guide and pass over the
platen.
•
Adjust the paper guides by removing them left or right to fit the paper width.
•
Close the printer top cover by lifting up the support and close the printer top slowly.
Rear Paper
Guide
Front Paper
Guides
Platen
PLEASE NOTE WHEN YOU ARE USING HORTICULTURAL LABELS
MAKE SURE THE LABELS ARE INSTALLED IN THE PRINTER SO THE
LABELS ARE COMING OFF THE BASE OF THE ROLL NOT OFF THE TOP.
THIS IS THE OPPOSITE OF THE DIAGRAM ON THE BASE
Fig. 11. External Roll Mount Label Installation 1
Fig. 12. External Roll Mount Label Installation 2
- 12
-
© Advanced Labelling Limited July 2008
Top Cover
Support
LabelStation Pro Series Set Up Manual July 2008
External Roll
Holder