Closing The Top Cover; To Open; To Close - LabelStation Pro200 series User Manual

2.3.3.

Closing the Top Cover

Please take care when opening or closing the printer's top cover by carefully following
these instructions.
2.3.3.1.
• When facing the front of the printer pull the cover release levers on both sides
of printer towards you.
• Lift up the top gradually.
• There are two stop positions for the top cover. Position 1 and 2 are indicated on
the label below.
To hold the cover open at position 1, you must lift the cover higher than the stopping point at
position 1 and gently lower the cover to stopping point 1. Do not let the cover free fall!
• Fully open the top cover and gently lower it to stop position 2.
2.3.3.2.
• To close the cover, lift up the top cover to the ultimate angle then close the top
cover gently and it will be kept at a stop position between 1 and 2 for a while.
• Use both hands to gently push down the top cover to close it and make sure the
cover is latched on both sides.

To Open

Fig. 15. Top cover support is fixed at position 2

To Close

Fig.16. Top cover is fully open and ready to close
- 14 -
© Advanced Labelling Limited July 2008
LabelStation Pro Series Set Up Manual July 2008