Codec C20 — The Physical Interface - Cisco C20 TelePresence System Administrator's Manual

Cisco TelePresence System Quick Set C20 and Profiles using C20
Contents
Codec C20 — The physical
interface
The front panel LEDs
The LED in front of the codec indicates the status of the
codec.
• When the LED is off the codec is Off.
• The LED flashes green during the boot up and shut down
of the codec.
• The LED pulses green when the infrared (IR) port is
activated. This will occur when the remote control is in
use.
• The LED is steady green when the codec is On, in
Standby mode or in Presentation mode.
• When the LED is red this indicates an Error has occurred.
D14637.10 Profile C20 and Quick Set C20 Administrator Guide TC6.1, APRIL 2013.
Introduction Web interface
Power Call
System settings
IR Alarm
(infrared)
www.cisco.com — Copyright © 2010-2013 Cisco Systems, Inc. All rights reserved.
114
Administrator Guide
Setting passwords Appendices Appendices