Networkservices Settings - Cisco C20 TelePresence System Administrator's Manual

Cisco TelePresence System Quick Set C20 and Profiles using C20
Contents

NetworkServices settings

NetworkServices XMLAPI Mode
Enable or disable the video system's XML API. For security reasons this may be disabled.
Disabling the XML API will limit the remote manageability with for example TMS, which no
longer will be able to connect to the video system.
Requires user role: ADMIN
Value space: <Off/On>
Off: The XML API is disabled.
On: The XML API is enabled (default).
NetworkServices XMLAPI Mode: On
Example:
NetworkServices MultiWay Address
The MultiWay address must be equal to the Conference Factory Alias, as configured on the
Video Communication Server. The Multiway™ conferencing enables video endpoint users to
introduce a 3rd party into an existing call.
Multiway™ can be used in the following situations:
1) When you want to add someone else in to your existing call.
2) When you are called by a 3rd party while already in a call and you want to include that person
in the call.
Requirements: The Codec C20 must run software version TC3.0 (or later), Video
Communication Server (VCS) version X5 (or later) and Codian MCU version 3.1 (or later). Video
systems invited to join the Multiway™ conference must support the H.323 routeToMC facility
message if in an H.323 call, or SIP REFER message if in a SIP call.
Requires user role: ADMIN
Value space: <S: 0, 255>
Format: String with a maximum of 255 characters (a valid dial URI).
NetworkServices MultiWay Address: "h323:multiway@company.com"
Example:
D14637.10 Profile C20 and Quick Set C20 Administrator Guide TC6.1, APRIL 2013.
Introduction Web interface System settings System settings
NetworkServices MultiWay Protocol
Determine the protocol to be used for MultiWay calls.
Requires user role: ADMIN
Value space: <Auto/H323/Sip>
Auto: The system will select the protocol for MultiWay calls.
H323: The H323 protocol will be used for MultiWay calls.
Sip: The SIP protocol will be used for MultiWay calls.
NetworkServices MultiWay Protocol: Auto
Example:
NetworkServices H323 Mode
Determine whether the system should be able to place and receive H.323 calls or not.
Requires user role: ADMIN
Value space: <Off/On>
Off: Disable the possibility to place and receive H.323 calls.
On: Enable the possibility to place and receive H.323 calls (default).
NetworkServices H323 Mode: On
Example:
NetworkServices HTTP Mode
Set the HTTP mode to enable/disable access to the system through a web browser. The web
interface is used for system management, call management such as call transfer, diagnostics
and software uploads.
NOTE: Restart the system for any change to this setting to take effect.
Requires user role: ADMIN
Value space: <Off/On>
Off: The HTTP protocol is disabled.
On: The HTTP protocol is enabled.
NetworkServices HTTP Mode: On
Example:
www.cisco.com — Copyright © 2010-2013 Cisco Systems, Inc. All rights reserved.
71
Administrator Guide
Setting passwords Appendices