Keyboard And Velocity Modulation Control - E-Mu Proteus Operation Manual

54
KYBD/ Velocity.Modulation
EDIT MENU
Modulation Sources:
Key Number and Key
Velocity
Destinations: Off,
Pitch, Primary Pitch,
Secondary Pitch,
Volume, Primary
Volume, Secondary
Volume, Attack,
Primary Attack,
Secondary Attack,
Decay, Primary
Decay, Secondary
Decay, Release,
Primary Release,
Secondary Release,
Crossfade, LFO 1
Amount, LFO 1 Rate,
LFO 2 Amount, LFO 2
Rate, Auxiliary
Envelope Amount,
Auxiliary Envelope
Attack, Auxiliary
Envelope Decay,
Auxiliary Envelope
Release, Sample
Start, Primary Sample
Start, Secondary
Sample Start, Pan,
Primary Pan,
Secondary Pan, Tone,
Primary Tone,
Secondary Tone
When Modulating
Envelope Attack,
Decay, or Release
Times:
Positive amounts of
modulation increase
the time.
Negative amounts of
modulation decrease
the time.

KEYBOARD and VELOCITY MODULATION CONTROL

These functions allow you to route keyboard and velocity information to
any of the modulation destinations on the Proteus. Up to 6 simultaneous
paths or "patches" may be programmed. For each modulation patch,
there is a source (keyboard or velocity), and a corresponding amount
parameter which is variable from -128 to +127. Place the cursor under the
appropriate parameter and change the patch number, modulation
source, modulation destination, or the amount using the data entry
control. If a parameter is not labeled either primary or secondary, it
affects both.
KEY/VELOCITY CTL
1 V>Attack -064
Patch
Number
Modulation
Source
LFO 1
Amount Freq.
LFO 2
Amount Freq.
Auxiliary
DAHDSR
Atk Dec Rel Amt
Keyboard and Velocity Modulation Sources
Modulation
Destination
Modulation
Amount
Primary
Instrument
Tone
Sample
Pitch
Start
X-Fade
Secondary
Instrument
Tone
Sample
Pitch Start
Modulation Destinations
KEYBOARD
CENTER
KEY NUMBER
Proteus operation manual
DCA Pan
Volume
AHDSR
Atk Dec Rel
Level
DCA Pan
Volume
AHDSR
Level
Atk Dec Rel
VELOCITY
CURVE
VELOCITY
R
L
R
L