E-Mu Proteus Operation Manual page 12

12
Power Up! Proteus operation manual
If a stereo plug is inserted, the Ring of the stereo plug serves as a signal
Return which sums into the Main outputs.
Therefore, the Sub 1 and Sub 2 jacks can serve as effect sends and returns
in order to further process selected instruments and then return them to
the main mix.
The diagram shows the Sub 1 and Sub 2 jacks being used as send/returns
in order to further process selected Proteus instruments without using
the effects bus on the mixing board. In a pinch, the effect returns could
also be used to sum additional instruments into the main outputs of the
Proteus.
Proteus Output Section
L Bus
R Bus
Tip Tip Tip Tip Tip Tip
Ring Ring Ring Ring Ring
R L R L R L
SUB 2 SUB 1 MAIN
The Sub 1 and Sub 2 jacks can be used as effect returns to the Main Outputs.
POWER UP!
The power switch is located on the left side of the front panel. The
Proteus and its MIDI controller may be turned on in any order. When
power is applied, the liquid crystal display will light, indicating that
the Proteus is operating.
You may have noticed that there is no 110/220 Volt power selector
switch on the Proteus.
Proteus automatically switches itself for 110 or 220 Volt operation.