Installation - Pentair EVERPURE PRO Installation And Operating Instructions Manual

INSTALLATION

Drain
Clamp
Optional Tank Installation
Installing the Water Supply Adapter
Read all installation and operating instructions
NOTE:
before installing and using your RO system.
The supply adapter fits 1/2-NPS supply threads. If local codes
permit, it may be used to connect the PRO to the cold water
supply line. If local codes do not permit the use of the supply
adapter, alternate connectors can be obtained from your local
plumbing wholesaler.
See Figure 2.
1. Turn off cold water supply line. If cold water line does not
have a shut-off valve under the sink, you should install one.
2. Turn on the cold water faucet and allow all water to drain
from line.
3. Disconnect cold water line from the threaded stub on
bottom of main faucet.
4. Apply plumber tape onto threads of faucet stub and supply
adapter. Screw the water supply adapter to the threaded
faucet stub as shown.
5. Using the nut that previously connected the cold water line
to the faucet, screw the cold water line to the male supply
adapter threads.
Supply
Adapter
Tank
White
Valve
Cold
Water
Green
Storage
Tank
Figure 1
EVERPURE
PRO-Reverse Osmosis Water Filtration System Installation and Operating Instructions
®
Drinking Water Faucet
Blue
Red
Membrane
Post-polishing
Housing
Filter Housing
Membrane
Post-polishing
Filter
Figure 2
Manifold
Cover
Manifold
Prefilter
Housing
Prefilter
• 5