Table of Contents
Advertisement
Port Shade Installation/Removal
- Reference illustrations on page 11.
1. Place the port shade on a flat surface with the cut-out
section face down (Fig. 1 - page11) .
2. Loosen the four set screws with the Allen wrench. The set
screws do not have to be removed, unscrew them until the
face of the set screw does not protrude beyond the inside
face of the dome shade.
3. Carefully place the port inside the shade with the
dome face down (Fig. 2 - page 11). The dome port should
rest on the two inner ledges of the shade (Fig.1 - page 11).
4. Hold the port in place and tighten the four set screws
with the allen wrench provided. Tighten the set screws
until the face of each set screw is even with the face of
the port shade (Fig. 2 - page 11).
10
Advertisement
Table of Contents
