Attaching Your Dome Port And Shade; Attaching The Port To A Housing - Ikelite 75342 Manual

Attaching Your Dome Port and Shade

Attaching the Port to a Housing

1. The Dome Shade should be aligned and attached as shown. DO
NOT overtighten the Dome Shade Set Screws or you may damage
the shade. Overtightening is identified by bending of the shade
base away from the port around each set screw. Slowly tighten the
set screws so they just make contact in the recessed areas and are
snug against the port.
NOTE: Use 1/8" hex key (supplied with Ikelite Housing) to tighten
or loosen Dome Shade Set Screws.
Thumbscrew
Port Mount
2. Using your fingers or a 7/64" hex key (included), loosen each
Thumbscrew until at least 5 threads are visible.
6
Dome Shade
Set Screw
Port Mount
Recess