Table of Contents
Advertisement
Deflector Removal/Installation
The factory installed flash Deflector should be removed when using
ONLY the built-in camera flash and no external strobes. Pull the
Deflector away from the inside of the housing front to remove. To install,
line up the corresponding Velcro dots on the housing front and press the
Deflector back into its factory installed position next to the lens port.
When properly installed, the Fiber
Optic Holes should line up with the
housing Fiber Optic Ports,
page 5.
Diffuser Purpose
When shooting close-up photographs, the lens port on the housing can
block a portion of the light from the built-in camera flash. This can result
in a shadow in a lower corner of the picture frame. The Diffuser will help
eliminate the shadow. In addition, you can zoom in if necessary.
Diffuser Installation/Removal
The included Diffuser should only be used when
shooting with the built-in camera flash. Always
remove the Deflector before using ONLY the
built-in camera flash and Diffuser.
To install the diffuser, push the "Cut-out" Section
into the port groove until it stops as shown. To
remove, grab the top of the Diffuser and pull
away from the port.
Note the Small Hole. To avoid losing the diffuser,
you can attach a fishing line or string to this hole.
10
Deflector
Diffuser properly
installed in port groove
Velcro
Diffuser
Cut-out
Section
Small hole
Fiber
Optic
Holes
Advertisement
Table of Contents
