Ikelite 5509.71 Quick Start Manual

Focus Gear & Clamp for Canon 100mm IS USM
Lens
Product Number - 5509.71
Included in the Box
•
Lens Ring - Canon 100mm IS USM # 0098.31
•
Port Gear Sleeve # 0073.1
•
Clamp # 9059.9
Installation and Use
Attach the Sleeve, Adapter and Clamp
1. Rotate Gear Sleeve Retainer counterclockwise and
remove using Gear Sleeve Retainer Tool.
2. Place Port Gear Sleeve into the housing Port Mount
opening.
3. Tighten Gear Sleeve Retainer into Port Mount using Gear
Sleeve Retainer Tool. Tighten clockwise so Retainer is
snug - Diagram A. DO NOT overtighten.
4. Slide Sleeve Adapter Small Slots into Gear Sleeve Posts
- Diagram B.
5. Gently expand and place Clamp over front of lens. Push
Clamp down to lens position shown - Diagram C.
6. Line up the two red dots on the camera face and bayonet
end of the lens.
7. Rotate lens focus ring until Clamp Tabs line up with
Sleeve Adapter Large Slots.
8. Lower lens and bayonet onto the camera body by rotating
lens clockwise - Diagram C.
9. Push clamp down on the lens until the Clamp Tabs slide
fully into the Sleeve Adapter Large Slots.
10. Rotate housing knob to check focus function.
11. Install Lens Port.
Diagram A
Gear Sleeve Retainer Tool
Port Mount
Diagram B
Gear Sleeve
Retainer
Gear Sleeve
Sleeve Adapter
Small Slots
Gear Sleeve
Posts