Design; Introduction - gledhill BoilerMate CP 120 Design, Installation & Servicing Instructions

DESIGN

Any water distribution system/installation must comply with the relevant
recommendations of the current version of the Regulations and British Standards
listed below:-
Gas Safety (Installation and use) Regulations 1998
Building Regulations
Requirements for Electrical Installations BS7671:2008 and A2:2013 17th Edition
Water Supply (Water Fittings) Regulations 1999
Manual Handling Operations Regulations
British Standards
BS EN 806:1-5: BS EN 8558:2011
Most new building work will require the relevant building control body to be notifi ed
prior to the building work commencing. This will not be required if the work is carried
out under a self certifi cation scheme or if the work is not notifi able. Full details of the
self certifi cation schemes and work that is not notifi able can be obtained from page
9 of Approved Document G, available from www.planningportal.gov.uk.
A suitably competent trades person must install the BoilerMate CP and carry out
any subsequent maintenance/repairs. In fact the appliance front cover is secured
by 2 screws and this should only be removed by a competent trades person. The
manufacturer's notes must not be taken as overriding statutory obligations.
The Domestic Building Services Compliance Guide 2013 defi nes, one of the fi xed
building services, as any part of or controls associated with fi xed systems for domestic
hot water. All fi xed building services, including theircontrols, should be commissioned
by testing and adjustment to ensure that they use no more fuel and power than is
reasonable in the circumstances. Where commissioning is required, if it is completed
by a person registered with a competent person scheme, the commissioning notice
will be supplied by that person, otherwise the person carrying out the work must notify
the relevant building control body, that commissioning has taken place in accordance
with the Domestic Heating Compliance Guide.The building control body will then be
able to issue a completion certifi cate. This applies to England, for other jurisdictions in
the UK, it may be necessary to consult their own building regulations and guidance.
The BoilerMate CP is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience or knowledge, unless
they have been given supervision or instruction concerning use of the appliance by
a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
The information in this manual is provided to assist generally in the selection of
equipment. The responsibility for the selection and specifi cation of the equipment
must however remain that of the customer and any Designers or Consultants
concerned with the design and installation.
Please Note: We do not therefore accept any responsibility for matters of design,
selection or specifi cation or for the eff ectiveness of an installation containing one of
our products unless we have been specifi cally requested to do so.
All goods are sold subject to our Conditions of Sale, which are set out at the rear of
this manual.
In the interest of continuously improving the BoilerMate CP range, Gledhill Building
Products Ltd reserve the right to modify the product without notice, and in these
circumstances this document, which is accurate at the time of printing, should be
disregarded. It will however be updated as soon as possible after the change has
occurred.

INTRODUCTION

Page 3