Design; Description - gledhill TEC140-OV Installation & Servicing Instructions Manual

Manufacturer: Gledhill Building Products Ltd
Max. mains inlet water pressure
Max. working pressure - Primary heat exchanger (Indirect models) 3.0bar
Max. working pressure - Solar heat exchanger (Solar models)
Max. working pressure - Open vented thermal store (All models) 10.0m (1.0bar)
Max. working pressure - Open vented central heating system
Max. working pressure - Sealed heating system
Max. flow rate - Measured by flow sensor
Min. flow rate - Measured by flow sensor
Immersion heater rating
The Torrent comes complete with plate heat exchanger. This has a very small
volume of water held within it, therefore any minimal expansion will be
accomodated in the supply pipe.
Handling Before Installation
The Torrent must be handled with care and stored the correct way up in a dry place.
Any manual handling/lifting operations will need to comply with the requirements
of the Manual Handling Operations Regulations issued by the H.S.E. The appliance
can be moved using a sack truck on the rear face although care should be taken and
the route should be even. In apartment buildings containing a number of storeys we
would recommend that the appliances are moved vertically in a mechanical lift. If it
is proposed to use a crane, expert advice should be obtained regarding the need for
slings, lifting beams etc. A specific manual handling assessment is shown in Appendix
B at the rear of this manual.
Maintenance
Modifications should not be made to this product. Replacement parts, including
immersion heaters, should be purchased from Gledhill Building Products Limited, or
agents approved by them. The manual must always be left with the Torrent.
The Environment
This product has been manufactured using many recyclable materials, including the
approved HCFC/CFC free polyurethane foam insulation. At the end of its useful life, it
should be disposed of at a Local Authority Recycling Centre, to maximise the products
full environmental benefits.
Note:
The thermal store is supplied with Immersion heaters. These incorporate a thermostat
(XB114) which cuts the electricity supply to the immersion heater if the control
thermostat fails - a thermal cut out. Under no circumstances fit an immersion heater
which does not incorporate a thermal cut out. If the thermal cut out operates the
thermostat (XB114) is no longer effective and must be replaced.
5.0bar
6.0bar
10.0m (1.0bar)
3.0bar
50 l/min
3.5 l/min
3kW @ 230V ac, 50Hz
Page 3

DESIGN

DESCRIPTION