A combined primary storage unit (cpsu) for domestic hot water supply and central heating
appliance category 1 2h
types c13:c53:c33
destination gb: ie, nox class 5 (52 pages)
Page 1
BMA 200 SP - SOL BMA 220 SP - SOL BMA 240 SP - SOL benchmark a sealed sYstem central Heating and mains...
Page 2
With the introduction of a self certification scheme, the Benchmark Logbook is being is manufactured under an iso 9001:2000 replaced by a similar document in the form of a commissioning check list and a service interval record is included with all gas appliance manuals.
Page 3
1.0 design 1.1 introduction SensorT3 provides a high temperature interlock The arrangement of a typical BoilerMate A-Class SP Solar installation is shown to de-activate the solar pump at a temperature schematically below. The basic unit which is covered by these instructions incorporates of 90ºC in the store.
Page 4
1.0 design 1.0 introduction *Increase to 350mm to provide the minimum maintenance access to comply with the Water Regulations if a ballvalve and overflow are being fitted. F & E Cistern appliance dimensions Model Height (A) Width (B) Depth (C) BMA 200-SP SOL 1330 BMA 220-SP SOL...
Page 7
2.0 installation 2.2 controls boilermate Heating/Hot water controls The Switch 6kW electrical emergency back up system is fitted to this appliance. This is The current BoilerMate SP Sol incorporates separate heating/hot water and solar switched on by moving the ‘mode’ rocker control systems.
Page 8
2.0 installation 2.2 controls solar controls The solar heat circuit circulation pump is controlled by the differential temperature The BoilerMate A-Class SP Sol appliance is supplied with a Danfoss electronic Solar between the solar collector and the store Heat Regulator ref SH-EO1 built into the appliance and the necessary temperature bottom.
Page 9
2.0 installation 2.2 controls function test For any further technical information/assistance The regulator is ready for operation when connected to the mains. The display regarding this product please ring the Gledhill becomes active and current temperatures are shown. Display updates once per Technical helpline on 01253 474401.
Page 10
Gledhill (Water Storage) AMD. MAY 2006 CONDITIONS OF SALE & WARRANTY TERMS AND FURTHER we will meet the contractors/installers 1. We only do business upon the Conditions which appear below and no other. Unless we so agree in writing these Conditions shall apply in full to any supply of goods by us to the exclusion of any Conditions reasonable costs in removing and replacing any defective or terms sought to be imposed by any purchaser.
Page 11
(a) we accept liability for death or personal injury to the extent that it results from our negligence that of our (i) shall be held in trust for us in a manner which enables employees agents or subcontractors. such proceeds to be identified as such, and : (ii) shall not be mixed with other monies nor paid into an (b) subject to paragraph (d) below, we accept liability for direct physical damage to tangible property to the overdrawn bank account.