Rudder Servo And Linkage Installation - Hangar 9 Twin Otter ARF Assembly Manual

Step 2
Slide a CA hinge into each of the pre-cut hinge slots in
the rudder leading edge.
Step 3
Slide the rudder hinges into the slots in the fin and
align the rudder with the top and bottom of the fin.
Twin Otter ARF Assembly Manual
Step 4
Remove the T-pins and apply 3–4 drops of thin CA to
each of the hinges. Allow the CA to cure without using
accelerator so it can penetrate the hinges completely.
Rudder Servo and Linkage
Installation
Parts Required
Fuselage Servo with hardware
7-inch steel pushrod Small control horns (2)
Copper sleeves (4) 82-inch rudder cable
Wire cable ends (2) EZ links (2)
Radio M3 x 4 screws (2)
Tools Required
Felt-tipped pen Pin vise
1/16-inch drill bit 5/64-inch drill bit
Needle-nose pliers #1 Phillips screwdriver
Sidecutters Pencil
Thin CA Ruler
Threadlock Hobby knife with #11 blade
Step 1
Prepare the rudder servo by installing the grommets
and bushings. Note that the bushings are installed
from the bottom of the servo.
29