Entering Program Mode; Create A Scene; Review A Scene Or Chase; Running A Program - Blizzard Lighting snokontrol User Manual

3.3 Programming
A program (bank) is a sequence of different scenes or steps which are called one after another.
SNOKONTROL can store up to 30 programs of 8 scenes each.

3.3.1 Entering Program Mode

1. Make sure that MANUAL mode is selected.
Press and hold the <PROGRAM> button until the Program LED blinks rapidly.
2.

3.3.2 Create A Scene

A scene is a static lighting look. Scenes are stored in banks. SNOKONTROL features 30 bank
memories, and each bank holds up to 8 scenes. In total, SNOKONTROL is capable of storing up
to 240 scenes.
Ensure that the BLACKOUT LED is not lit. If it is, press the <BLACKOUT> button
1.
to deselect.
2. Press and hold the <PROGRAM> button until the Program LED blinks rapidly.
3. Set the SPEED and FADE TIME sliders at their lowest level.
4. Select the fixture(s) you wish to include in the scene by pressing the appropriate
<SCANNER> buttons.
5. Create your look by using the sliders.
6. Tap the <MIDI/ADD> button.
Using the <BANK UP> and <BANK DOWN> buttons, select a bank from
7.
Using the <SCENES> button, select the scene (1-8) that you wish to program. All
8.
LEDs will flash to confirm. The LED display will indicate the scene number (
which was programmed.
9. Repeat steps 5-7 as necessary. Up to 8 scenes may be recorded to each program
bank.
10. To exit program mode, press and hold the <PROGRAM> button.

3.3.2.1 Review A Scene Or Chase

This section assumes that you have already recorded scenes and chases in the controller.
To Review a Scene:
1. Select any one of the 30 banks by pressing the <BANK UP>/<BANK DOWN>
buttons.
2. Select a <SCENE> button (1-8) to review.
3. Move the faders to change fixture attributes.
To Review a Chase:
Press any one of the 6 <CHASE> buttons.
1.
Press the <TAPSYNC DISPLAY> button to view the step number on the display.
2.
Press the <BANK UP>/<BANK DOWN> buttons to review all scenes in the chase.
3.

3.3.3 Running A Program

1. Use the <BANK UP>/<BANK DOWN> buttons to change program banks as
needed.
01-30 .
1-8
)
SNOKONTROL Manual Rev B.
Page 11