Removing The Library Controller; Replacing The Library Controller; Figure 65 Remove The Library Controller - Qualstar Q24 Installation And Operation Manual

Q24 Tape Library
5.5 Removing the library controller
Adhere strictly to the following steps to remove a power supply:
1. Power down the library by pressing the power button on the front panel.
2. Remove the power cord from the rear panel of the library.
3. Remove all cables from the library controller on the rear panel of the library.
4. Loosen the blue thumbscrews located on the library controller with your fingers.
5. Pull the library controller straight out of the library as shown below.
6. To store or ship the removed library controller, repackage it in the original or replacement device
packaging materials.
5.6 Replacing the library controller
Use this procedure to replace the library controller with another library controller:
1. Remove the library controller from the library, as described above.
2. To install the new library controller, see Section 2.10
© Copyright QUALSTAR 2014
Figure 65 Remove the library controller
Installation and Operations Manual
82