Qualstar Q24 Installation And Operation Manual page 83

Q24 Tape Library
Error Description
Code
D4 UART Error.
Frame overrun or Parity
Error on serial
Interface.
D5 Display Error
Communication to
display failed
D6 Memory Error, Stack
and heap overflow.
D7 Fatal system error
D8 Data base error
D9 No SCSI IC detected
DA In Library Verify Test
the barcode reader has
read different barcode
data for the same
cartridge label
DB Warning event!
See section below
DC I²C Bus Failure
DD Warning event!
See section below
DE Warning event!
See section below
DF Warning event!
See section below
E0 Incompatible magazine
detected
© Copyright QUALSTAR 2014
User Action
Retry operation; after
several occurrences
contact technical support
Retry operation; after
several occurrences
contact technical support
Retry operation; after
several occurrences
contact technical support
Retry operation; after
several occurrences
contact technical support
Retry operation; after
several occurrences
contact technical support
Retry operation; after
several occurrences
contact technical support
Check barcode label on
scratch cartridge and run
Library Verify Test again.
If the error recurs,
contact technical support
Retry operation; after
several occurrences
contact technical support
Check type of lowest left
magazine
Installation and Operations Manual
Critical Component Status
Check library and media changer
controller
Check library controller and OCP
Library controller probably defective.
Library controller probably defective.
Probably a hardware problem, check
library controller
Library controller probably defective.
Probably a hardware problem, check
library controller
SCSI controller probably defective.
Check SCSI controller and library
controller
Failure in I²C bus communication.
Check library controller and connections
to OCP and backplane.
Check OCP.
Check backplane.
Check drive sleds.
Magazine type not supported.
74