The display unit
Flush surface screw
(5 mm × 9 mm)
Truss head screw
(5 mm × 8 mm)
Installation using the screw holes
on the side of this product
1 Fasten the unit to the factory radio-
Position this product so that its screw holes
are aligned with the screw holes of the brack-
et, and tighten the screws at three or four lo-
cations on each side. Use either the truss
head screws (5 mm × 8 mm) or flush surface
screws (5 mm × 9 mm), depending on the
shape of the bracket's screw holes.
If the tab interferes with installation,
you may bend it down out of the way.
Factory radio-mounting bracket
Truss head screw or
flush surface screw
Be sure to use the
with this product.
Dashboard or console