Configuring Radius Accounting - AudioCodes MediaPack MP-118 User Manual

User's Manual
37.3

Configuring RADIUS Accounting

The the RADIUS Parameters page allows you to enable RADIUS accounting of SIP calls
by a RADIUS accounting server. The device can send the accounting messages to the
RADIUS server upon call release, call connection and release, or call setup and release.
Notes:

To configure RADIUS accounting:
1. Open the RADIUS Parameters page (Configuration tab > VoIP menu > SIP
Definitions submenu > RADIUS Parameters Settings).
2. Configure the parameters as required.
3. Click Submit.
The table below describes the RADIUS Accounting CDR attributes included in the
communication packets transmitted between the device and a RADIUS server.
Table 37-3: Supported RADIUS Accounting CDR Attributes
Attribute Attribute
Number Name
Request Attributes
1 user-name
4 nas-ip-
address
6 service-type
26 h323-
incoming-
conf-id
Version 6.6
•
For RADIUS accounting settings to take effect, you must save the
settings to flash memory with a device reset.
•
For a description of the RADIUS accounting parameters, see 'RADIUS
Parameters' on page 457.
Figure 37-3: RADIUS Accounting Parameters Page
Vendor
Specific
Attribute
(VSA) No.
- Account number or
calling party number
or blank
- IP address of the
requesting device
- Type of service
requested
1 SIP call identifier
37. Reporting Information to External Party
Value
Purpose
Format
String
up to 15
digits
long
Numeric 192.168.14.43
Numeric 1: login
Up to 32
octets
383
Example AAA
5421385747 Start Acc
Stop Acc
Start Acc
Stop Acc
Start Acc
Stop Acc
- Start Acc
Stop Acc
MP-11x & MP-124