Relay Mode For T.30 And V.34 Faxes; Support - AudioCodes MediaPack MP-118 User Manual


To use bypass mode for T.30 and V.34 faxes:
1. In the Fax/Modem/CID Settings page, do the following:
a. Set the 'Fax Transport Mode' parameter to Bypass (FaxTransportMode = 2).
b. Set the 'V.22 Modem Transport Type' parameter to Enable Bypass
(V22ModemTransportType = 2).
c. Set the 'V.23 Modem Transport Type' parameter to Enable Bypass
(V23ModemTransportType = 2).
d. Set the 'V.32 Modem Transport Type' parameter to Enable Bypass
(V32ModemTransportType = 2).
e. Set the 'V.34 Modem Transport Type' parameter to Enable Bypass
(V34ModemTransportType = 2).

To use bypass mode for V.34 faxes, and T.38 for T.30 faxes:
1. In the Fax/Modem/CID Settings page, do the following:
a. Set the 'Fax Transport Mode' parameter to Relay (FaxTransportMode = 1).
b. Set the 'V.22 Modem Transport Type' parameter to Enable Bypass
(V22ModemTransportType = 2).
c. Set the 'V.23 Modem Transport Type' parameter to Enable Bypass
(V23ModemTransportType = 2).
d. Set the 'V.32 Modem Transport Type' parameter to Enable Bypass
(V32ModemTransportType = 2).
e. Set the 'V.34 Modem Transport Type' parameter to Enable Bypass
(V34ModemTransportType = 2).

13.2.2.2 Relay Mode for T.30 and V.34 Faxes

In this scenario, V.34 fax machines are forced to use their backward compatibility with T.30
faxes and operate in the slower T.30 mode.

To use T.38 mode for V.34 and T.30 faxes:
1. In the Fax/Modem/CID Settings page, do the following:
a. Set the 'Fax Transport Mode' parameter to Relay (FaxTransportMode = 1).
b. Set the 'V.22 Modem Transport Type' parameter to Disable
(V22ModemTransportType = 0).
c. Set the 'V.23 Modem Transport Type' parameter to Disable
(V23ModemTransportType = 0).
d. Set the 'V.32 Modem Transport Type' parameter to Disable
(V32ModemTransportType = 0).
e. Set the 'V.34 Modem Transport Type' parameter to Disable
(V34ModemTransportType = 0).
13.2.3 V.152 Support
The device supports the ITU-T recommendation V.152 (Procedures for Supporting Voice-
Band Data over IP Networks). Voice-band data (VBD) is the transport of modem, facsimile,
and text telephony signals over a voice channel of a packet network with a codec
appropriate for such signals.
For V.152 capability, the device supports T.38 as well as VBD codecs (i.e., G.711 A-law
and G.711 μ-law). The selection of capabilities is performed using the coders table (see
'Configuring Coders' on page 189).
When in VBD mode for V.152 implementation, support is negotiated between the device
and the remote endpoint at the establishment of the call. During this time, initial exchange
of call capabilities is exchanged in the outgoing SDP. These capabilities include whether
User's Manual 154
MP-11x & MP-124
Document #: LTRT-65422