Desa VH Series Stove"VICTOR HEARTH" Owner's Operation And Installation Manual page 9

Burner system
assemBLy
Continued
INSTALLING B-VENT BURNER
SYSTEM INTO STOVE BODY
1. Carefully lift burner system and place into
stove body from the rear of stove.
2. Place the left and right grate tops into the
top of stove body. Discard center grate top
of stove and replace with center grate top
provided with burner system.
Center Top Grate
(Included with Burner
System)
Left Top
Grate
Cast Iron
Stove Body
Figure 15 - Installing Burner System Into
Cast Iron Stove Body
INSTALLING OPTIONAL BLOWER
ACCESSORY
NOTICE: If installing blower in
an existing stove burner system
with gas connections, shut off
gas supply and disconnect heater
from gas supply. Contact a quali-
fied service person to do this.
1. Remove 4 hex screws securing rear cover
to back of stove body (see Figure 16).
2. Separate bottom cover from rear cover
by loosening the 8 mounting screws (see
Figure 16).
112127-01C
3. Align the holes in the top mounting tabs
4. Thermostat Blower Only: Attach thermal
Right Top
Grate
Stove Body
Burner
System
Figure 16 - Removing Rear Cover and
Blower
Control
Knob
Control Shaft
Thermal Switch
and Bracket
Mounting
Holes
Figure 17 - Blower Assembly, Speed
Control, and Thermal Switch Locations
www.desatech.com
of blower with the holes in wall of rear
cover. Using the 4 screws provided, mount
blower and tighten screws securely (see
Figure 17).
switch and bracket to inside rear cover
wall with two hex head screws provided
as shown in Figure 17. After securing
bracket to rear cover, carefully bend along
existing bend line on bracket to almost a
90° angle (see Figure 17). This will allow
thermal switch to be positioned against
stove rear wall and sense temperature
when in operating mode.
Hex Screws
Bottom
Cover
Bottom Cover from Stove Body
Locknut
Blower
Assembly
Rear
Cover
Mounting
Screws
Speed
Control
TOP VIEW
Screws
9