Desa VH Series Stove"VICTOR HEARTH" Owner's Operation And Installation Manual page 22

instaLLation
Continued
2. Remove the screws from the 2 tabs at the
top of the glass door while holding door
securely keeping it from falling forward
(see Figure 40).
3. Grasp door by both sides and ease it
upward off of the lower bracket (see
Figure 40).
4. To replace glass door, follow the above
instructions in reverse.
Screw
Glass
Door
Figure 40 - Removing Glass Door from
Burner System
INSTALLING LOGS, LAVA ROCK,
AND GLOWING EMBERS
WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically ap-
proved with this burner system
may result in property damage
or personal injury.
It is very important to install these logs exactly
as instructed in Figures 41 through 45 . Do
not modify logs. Only use logs supplied with
freestanding burner system. Do not use if any
log(s) are broken (see Replacement Parts,
page 32).
1. Remove glass door. See Removing/Re-
placing Glass Door, page 21.
2. Place log #1 (back log) on top of grate.
Make sure the notches in the bottom of the
log fit over the grate (see Figure 41).
3. Rest log #2 (large front log) on the pins on
the front part of the grate (see Figure 42).
22
4. Place log #3 (crossover log) onto the rear
and front logs. Make sure it is seated
properly into the notch on the front log
and over the raised triangular portion of
the rear log as shown in Figure 43.
Figure 41 - Installing Log No. 1
Figure 42 - Installing Log No. 2
Figure 43 - Installing Log No. 3
www.desatech.com 112127-01C