Desa VH Series Stove"VICTOR HEARTH" Owner's Operation And Installation Manual page 24

oPeration
Continued
LIGHTING
INSTRUCTIONS
1. STOP! Read the safety information
page 23.
2. Set ON/OFF switch located on rear
cover to OFF.
3. Open lower panel.
4. Turn off all electric power to the burner
system.
5. Push in gas control knob slightly and
turn clockwise
6. Wait five (5) minutes to clear out any
gas. Then smell for gas, including near
the floor. If you smell gas, STOP! Fol-
low "B" in the safety information page
23. If you don't smell gas, go to the next
step.
7. The pilot is located by the main burner
and should not require accessing for
lighting.
8. Turn knob on gas control counterclock-
wise to PILOT.
9. Push in control knob all the way and
hold. Immediately light the pilot by
repeatedly depressing the piezo spark
ignitor until a flame appears. Continue
to hold for about one (1) minute after
the pilot is lit. Release knob and it will
pop back. Pilot should remain lit. If it
goes out, repeat steps 5 through 8.
• If knob does not pop up when re-
leased, stop and immediately call your
service technician or gas supplier.
• If the pilot will not stay lit after several
tries, turn the gas control knob to OFF
and call your service technician or
gas supplier.
10. Turn gas control counterclockwise
to ON.
11. Turn on all electric power to the burner
system.
12. Turn the ON/OFF switch to ON position.
13. Close lower panel.
14. To leave pilot lit and shut off burners
only, turn control knob clockwise
to the PILOT position or set
selector switch in the OFF position.
24
to OFF.
www.desatech.com
Piezo
Ignitor
Gas Control Knob
Figure 46 - Control Valve
TO TURN OFF GAS
TO APPLIANCE
1. Set ON/OFF switch located on rear
cover to OFF.
2a. Open lower panel.
2b. If Using Optional Hand-Held Remote:
Set selector switch in the OFF position
to prevent draining battery.
3. Turn off all electrical power to the ap-
pliance if service is to be performed.
4. Push in gas control knob slightly and
turn clockwise
5. Close lower panel.
6. Close equipment shutoff valve (see
Figure 30, page 19).
MANUAL LIGHTING
PROCEDURE
1. Remove glass door (see Removing/Re-
placing Glass Door, page 21).
2. Follow steps 1 through 8 under Light-
ing Instructions.
3. Depress control knob and light pilot
with match.
4. Keep control knob pressed in for 30
seconds after lighting pilot. After 30
seconds, release control knob. Now
follow steps 10 through 13 of Lighting
Instructions.
5. Replace glass door (see Removing/Re-
placing Glass Door, page 21).
OPTIONAL REMOTE
OPERATION
Note: All remote control accessories must
be purchased separately (see Accesso-
ries, page 33). Follow instructions included
with the remote control.
NOTICE: You must light the pilot
before using the hand-held re-
mote control unit. See Lighting
Instructions.
to OFF.
112127-01C