Desa VH Series Stove"VICTOR HEARTH" Owner's Operation And Installation Manual page 10

Burner system
assemBLy
Continued
5. Place speed control on left inside of rear
cover and push the plastic control shaft
through opening (see Figure 17, page 9).
6. While supporting speed control, secure
control shaft with lock nut by pushing and
turning lock nut with pliers clockwise until
tight against the side of rear cover. Place
control knob provided onto shaft.
7. Place the green ground wire between the
bottom hole on the blower assembly and the
hex screw and tighten (see Figure 18).
8. Connect the blue wire on the blower as-
sembly to one side of the thermal switch
(see Figure 18).
9. Connect the black wire to the other side
of the thermal switch (see Figure 18).
10. Connect the white wire to the other terminal
on the blower motor assembly (see Figure
18). Make sure the thermal switch has
been properly installed to fit against back
of burner system insert after the rear cover
assembly has been reinstalled.
Speed
Control
Black
Wire
Thermal
Switch
Blue
Wire
Green
Ground Wire
Screw
Figure 18 - Blower Wiring Layout
10
Power Cord (Route
Through Plastic
Bushing in Bottom
Cover When
Assembled)
White
Wire
Wiring Diagram
Decal
www.desatech.com
11. Make sure all wire connections to termi-
nals on blower motor and thermal switch
are securely attached and that the screw
retaining the green ground wire is tight.
12. Check to make sure that the power cord is
completely clear of the blower wheel and
that there are no foreign objects in blower
wheel.
WARNING: Never touch the
blower wheel while in operation.
13. Peel off the backing paper and stick the
supplied wiring diagram decal on the inside
of rear cover as shown (see Figure 18).
14. Reattach bottom cover to rear cover with
8 screws (see Figure 16, page 9). Make
sure that you don't pinch any wires during
reassembly. Route power cord through
plastic bushing in bottom of rear cover.
WARNING: Failure to position
the parts in accordance with sup-
plied diagrams or failure to use
only parts specifically approved
with this heater may result in
damage or personal injury.
INSTALLING REAR COVER
1. Place rear cover behind stove body. Rear
cover will rest on the bottom ledge of the
stove body.
2. Using hex screws provided, attach rear
cover to back of stove body. See Figure
19, page 11. IMPORTANT: This rear cover
must be securely in place before venting
pipes are installed.
3. Open lower door panel. The valve is
attached to the underside of the burner
system assembly.
4. Connect or reconnect gas supply, see
Connecting Stove/Burner System to Gas
Supply on page 18.
WARNING: A qualified in-
staller or service person must
connect burner system to gas
supply. Follow all local codes.
112127-01C