Venting Installation - Desa VH Series Stove"VICTOR HEARTH" Owner's Operation And Installation Manual

Cast iron stove and b-vent (freestanding fireplace heater) burner system
Table of Contents

Advertisement

Burner system
assemBLy
Continued
Hex Screws
Figure 19 - Installing Rear Cover (Shown
with Optional Blower Accessory)

ventinG instaLLation

WARNING: Read all instruc-
tions completely and thoroughly
before attempting installation.
Failure to do so could result in
serious injury, property dam-
age, or loss of life. Operation of
improperly installed and main-
tained venting system could
result in serious injury, property
damage, or loss of life.
NOTICE: Failure to follow
these instructions will void the
warranty.
112127-01C
Rear Cover (Shown with
Optional Blower)
Blower Power
Cord
www.desatech.com
INSTALLATION PRECAUTIONS
Consult local building codes before beginning
installation. Only a qualified service person
should install venting system. The installer
must follow these safety rules:
• Wear gloves and safety glasses for
protection
• Use extreme caution when using ladders
or when on roof tops
• Be aware of electrical wiring locations in
walls and ceilings
The following actions will void the warranty
on your venting system:
• Installation of any damaged venting com-
ponent
• Unauthorized modification of the venting
system
• Installation of any component part not
manufactured or approved by DESA
• Installation other than as instructed by
these instructions
Your DESA stove with B-vent burner system
is approved for use with any listed gas vent.
A listed gas vent is a factory made and listed
system designed, and installed exclusively for
removing products of combustion, excess air,
and dilution air resulting from burning fuel gas.
Metal vents, the most common type of vent,
employ double wall construction enclosing
an insulating air space. This air space both
helps keep flue gases warm and reduce
heat transferred to nearby combustibles. This
appliance is equipped with a safety control
system designed to protect against improper
venting of combustion products.
It is very important that the venting system
maintain its balance between the combustion
air intake and the flue gas exhaust. Certain
limitations apply to vent configurations and
must be strictly followed.
WARNING: This gas stove
with burner system and vent as-
sembly must be vented directly
to the outside. The venting sys-
tem must NEVER be attached to a
chimney serving a separate solid
fuel burning appliance.
11

Advertisement

Table of Contents
loading

Table of Contents