Desa VH Series Stove"VICTOR HEARTH" Owner's Operation And Installation Manual page 7

Burner system
assemBLy
Continued
9. Fasten each leg to stove with four (4) M8
x 1.25 - 20 mm bolts. Use a flat washer
and lock washer with each bolt. Tighten
bolts into threaded holes on stove body
(see Figures 9 and 10). Use an adjustable
wrench or a 12 mm socket.
10. Attach stove door by inserting step bolt
through door hinge pivot hole and into
threaded hole in stove body (see Figures
9 and 11). Use an adjustable wrench
or a 12 mm socket to fasten step bolt.
Tighten step bolt until snug. Make sure
door moves freely.
11. Install door catch bolt (M8 x 1.25-55 mm
with two M8 hex nuts) into threaded hole
on stove body (see Figure 9). Use an
adjustable wrench or a 12 mm socket.
The catch bolt has two hex nuts attached
to it (see Figure 12). The top nut is a bolt
stop and the bottom nut is for door leveling
adjustment.
Bolt
Pallet Wood
Figure 8 - Removing Pallet Wood From
The Bottom of The Stove
Door Hinge
Step Bolt Hole
Front
Bottom Of
Stove Unit
Figure 9 - Locating Threaded Holes for
Legs and Door Attachment
112127-01C
Pallet Wood
Front
Bottom Of
Stove Unit
Door Catch Bolt
With Adjustable
Hex Nuts Hole
Leg
Hole
www.desatech.com
12. Check general catch bolt alignment with
door claw. Make final adjustment and door
leveling after stove is in normal standing
position.
13. Carefully lift stove back up on its four at-
tached legs.
Washers
Bolt
Figure 10 - Attaching Stove Legs
(Oxford™ Model Shown)
Stove Door
Door Hinge
Step
Bolt
Bolt Shoulder
Figure 11 - Attaching Stove Door
Door
Door Claw
Catch
Bolt
Figure 12 - Catch Bolt and Door Claw
Orientation
Bottom Of
Stove Unit
Leg
Threaded
Hole
Bolt Stop
Adjusting
Nut
7