Desa VH Series Stove"VICTOR HEARTH" Owner's Operation And Installation Manual page 8

Burner system
assemBLy
Continued
Removing Front Surround Panel
Remove 2 bolts from bottom of stove and
set aside. Remove bolt from the top of the
stove to remove the front panel assembly
(see Figure 13).
Stove Body
Front
Assembly
Figure 13 - Removing Front Assembly
(Oxford™ Model Shown)
REMOVING SCREEN (OPTIONAL)
Amity Models
1. Lay the front panel assembly face down
on a protected surface. Remove the two
screws that hold the front plate onto the
front surround plate (see Figure 14). Save
these screws.
2. Remove the screws and washers that
hold the screen onto the front surround
plate. Discard these screws, washers,
and screen (see Figure 14).
3. Replace the two screws from step 1 to
reassemble the front plate and the front
surround plate. Set this assembly aside
until burner system has been installed,
logs have been placed inside of burner
system, and glass door to burner system
insert has been replaced.
8
Front
Surround
Plate
Screw with
Washer
Bolt
Screen
Front Plate
Screw with
Washer
Screen
Front Surround
Plate and Doors
Oxford™ or Victor Hearth™ Models
Figure 14 - Removing Screen from Front
Oxford or Victor Hearth Models
1. Lay the front panel assembly face down
on a protected surface. Remove the
screws and washers that hold the screen
onto the front surround plate. Discard
these screws, washers, and screen (see
Figure 14).
2. Set this assembly aside until burner sys-
tem has been installed, logs have been
placed inside of burner system, and glass
door to burner system insert has been
replaced.
www.desatech.com
Screws
Amity™ Model
Assembly
112127-01C