Inspecting Burners - Desa VH Series Stove"VICTOR HEARTH" Owner's Operation And Installation Manual

oPeration
Continued
Note: Do not hold the hand-held remote for
a long time. Body temperature will affect
its operation in the AUTO mode.
Safety Features
When away from home for an extended
period of time or as a child safety feature
to prevent accidental ignition of the burner
system, the receiver ON/OFF/REMOTE
switch should be in the OFF position.
Auto Shutoff Feature
1. If the average room temperature
reaches a range of 82° F (28° C) to 92°
F (33° C), the hand-held remote control
will perform a safety override and shut
the burner system off. This feature is
not available in the MANU mode.
2. The receiver continuously receives
signals from the hand-held remote
to control the room temperature. If
the hand-held remote is misplaced,
obstructed or for any reason cannot
transmit to the receiver, the receiver
will shut off the burner system. This
will occur in 8 or more minutes depend-
ing upon location of remote transmitter
and strength of batteries.
Key Pad Lock Feature
This feature allows the user to lock/unlock
the keypad on the hand-held remote in
the MANU or AUTO mode to prevent inad-
vertent operation (i.e. children operating
the hand-held remote control, etc.). The
keypad is locked in either on or off. Press
the POWER and LOCK buttons together to
turn the unit on or off.
OPERATING OPTIONAL
GWMT1 WALL MOUNTED
THERMOSTAT
WARNING: Do not connect
the thermostat to a power source.
Electrical shock and/or a fire haz-
ard will occur.
Light the burner system as instructed in
Lighting Instructions on page 24. Set wall
thermostat to desired temperature.
This thermostat has been electronically
calibrated at the factory and requires no
adjustment or leveling.
26
Upon installation, the thermostat must be
allowed to stabilize at room temperature
for a minimum of 30 minutes for proper
operation.
To turn the burner system off, adjust ther-
mostat to the lowest setting and turn the
gas control knob back to PILOT. The pilot
will remain lit.
IMPORTANT: To turn the pilot off, turn
the control knob on the heater to the OFF
position.
Blower controls are located on the left side
of the rear cover when standing in front of
stove with burner system installed.
The CDA3620TB thermostatically-con-
trolled blower has an ON setting and an
OFF setting. The blower will only run when
the switch is in the ON position. In the OFF
position, the blower will not operate.
If you are using CDA3620TB blower with
optional thermostat (wall mount or remote
control) for the burner system, your burner
system and blower will not turn on and off
at the same time. The burner system may
run for several minutes before the blower
turns on. After the burner system modu-
lates to the pilot position, the blower will
continue to run. The blower will shut off
after the burner system firebox tempera-
ture decreases.
The blower helps distribute heated air
from the stove. Periodically check the top
grates of the stove and remove any dust,
dirt, or other obstructions that will hinder
the flow of air.

insPectinG Burners

Check pilot flame pattern and burner flame
patterns often.
PILOT ASSEMBLY
The pilot assembly is factory preset for the
proper flame height. Alterations may have
occurred during shipping and handling. Call
a qualified service person to readjust the pilot
if necessary.
The height of the thermopile must be 3/8" to
1/2" above the pilot flame as shown in Figure
50, page 27. The flame from the pilot burner
must extend beyond the thermopile.
www.desatech.com
OPERATING OPTIONAL
BLOWER ACCESSORY
112127-01C