Chapter 4 Jumper Settings And Connectors; Jumpers And Connectors; Setting Jumpers - Advantech PPC-L127T User Manual

Chapter 4 Jumper Settings and Connec-

4.1 Jumpers and Connectors

4.1.1 Setting jumpers

You can configure your panel PC to match the needs of your application
by setting jumpers. A jumper is the simplest kind of electrical switch. It
consists of two metal pins and a small metal clip (often protected by a
plastic cover) that slides over the pins to connect them. To "close" a
jumper, you connect the pins with the clip. To "open" a jumper you
remove the clip. Sometimes a jumper will have three pins, labeled 1, 2,
and 3. In this case, you would connect either pins 1 and 2 or pins 2 and 3.
open
The jumper settings are schematically depicted in this manual as follows:.
open
A pair of needle-nose pliers may be helpful when working with jumpers.
If you have any doubts about the best hardware configuration for your
application, contact your local distributor or sales representative before
you make any changes.
PPC-L127T User Manual
tors
closed
closed
closed 2-3
1 2 3
closed 2-3
22