Installing The Tail Panels - ROBBE Arcus V-Tail EDF ARF Building And Operating Instructions

1
Fig. 1
- The illustration shows both V-tail halves with the hard pla-
stic joiner prior to assembly.
4
Fig. 4
- Finally fix the tailplane to the fuselage using the supplied
screws inserted from below and thread the pushrods into
the openings in the control horns. Dont screw the push-
rods on yet!
4
Building and Operating Instructions Arcus V-Tail EDF
2
Fig. 2
- Using Ropoxi 5-minute epoxy, glue both V-tail halves to the
hard plastic joiner.Allow the glue joint to harden.
5
Fig. 5
- Set the servo to centre (neutral) using the transmitter.
You can install a second optional servo for the rudder func-
tion if desired (see marking). If using this option, the V-tail
mixer must be used in your radio.
3
Fig. 3
- Place the V-tail unit into the opening in the fuselage. The
hard plastic joiner guide spigot must be inserted into the
guide tube in fuselage. Reinforce the tail to fuselage joint
with a 50 mm long strip of Tesa adhesive tape (see small
illustration on right)
6
Fig. 6
- Check the servo neutrals once more. The servo arm must be
at right angles to the servo.
Now you can permanently screw the pushrod to the control
horns.
No. 2592