Subscribe to Our Youtube Channel
Related Manuals for Cypress DPX-5500 Series
Summary of Contents for Cypress DPX-5500 Series
- Page 1 DPX-5500 Series Wireless Reader Extenders Operations Manual Model DPX-5510 Shown MAN-FA-DPX-5500 v1.00 ©2008 Cypress Computer Systems,Inc. • www.cypressworld.com 3/4/08 Page 1...
- Page 2 Data 0 /Clock Aux Digital I/O #2 Input +5 VDC Aux Digital I/O #1 Output Ground Aux Digital I/O #3 Input +8 - 24 VDC Alarm Digital Input Duprex Remote Unit ©2008 Cypress Computer Systems,Inc. • www.cypressworld.com 3/4/08 Page 2...
- Page 3 Strobed Rising Edge (Dorado 644) Strobed Rising (Mag-Tek) Strobed Falling Edge 6 x x Reserved 7 x x x Reserved All settings except Switch 5 are the same for Central and Remote units. ©2008 Cypress Computer Systems,Inc. • www.cypressworld.com 3/4/08 Page 3...
- Page 4 Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. ©2008 Cypress Computer Systems,Inc. • www.cypressworld.com 3/4/08 Page 4...
- Page 5 The Cypress Duprex RF is the newest member of the Suprex family of products. The Duprex RF 5500 series supports a wide range of additional features from previous versions of the Suprex RF family. Additional features: -- DES56 Encryption for secure communications --No channel selection is required as the units are preconfigured at the factory.
- Page 6 Distances given are typical line of sight. Actual distance will vary depending upon terrain, RF environment, and height of antenna. Duprex Specifications: Wiegand and Magstripe formats field selectable See Duprex manual for details. ©2008 Cypress Computer Systems,Inc. • www.cypressworld.com 3/4/08 Page 6...
- Page 7 The units as shipped are configured as a matched pair and are ready to plug in and operate. Both units need to have the antenna and a suitable power supply installed. ©2008 Cypress Computer Systems,Inc. • www.cypressworld.com 3/4/08 Page 7...
- Page 8 During setup or troubleshooting it may be necessary to observe the communication link between the Central and Remote units. The rapid polling used in the Setup / Config mode can help indicate whether the units can “See” each other. ©2008 Cypress Computer Systems,Inc. • www.cypressworld.com 3/4/08 Page 8...
- Page 9 Turn off DIP Switch #1 on both units to place them in normal operational mode. Communication Diagnostic LED (Red/Green/Yellow multi color) Activity LED (Amber) LED Indicator Location reference Power LED (Green) ©2008 Cypress Computer Systems,Inc. • www.cypressworld.com 3/4/08 Page 9...
- Page 10 Once the connection, setup, and configuration have been completed with both units, field installation and final commissioning can be done. ©2008 Cypress Computer Systems,Inc. • www.cypressworld.com 3/4/08 Page 10...
-
Page 11: Mounting The Units
(See Cypress Application Note “Site Evaluation for Duprex RF products”). This section of the document covers units that utilize the enclosure mounted1/2 wave whip antenna. - Page 12 Best, antenna has line of sight to other unit and is clear of adjacent metal objects. In all cases the antennas MUST be mounted at a distance of 20 cm or greater from any nearby persons ©2008 Cypress Computer Systems,Inc. • www.cypressworld.com 3/4/08 Page 12...
- Page 13 Screw placed in knockout. Screw knockout on it with screwdriver blade. Be careful not to damage interior components. Knockout end seal tabs Seal tab placed over knockout after screw has been fastened in place. ©2008 Cypress Computer Systems,Inc. • www.cypressworld.com 3/4/08 Page 13...
- Page 14 Select a type of mounting screw based on the type of material. Corner Channel Mounting Screws Placement of screw in corner channel. Screw placed into channel. Fasten screws in place with long handled screwdriver. ©2008 Cypress Computer Systems,Inc. • www.cypressworld.com 3/4/08 Page 14...
-
Page 15: Final Checkout
30 seconds of both units having power applied in Normal mode. Check operation of Badge reader, LED and other I/O in Normal mode. Insert cover mounting screws and tighten. Installation is complete. ©2008 Cypress Computer Systems,Inc. • www.cypressworld.com 3/4/08 Page 15...
Need help?
Do you have a question about the DPX-5500 Series and is the answer not in the manual?
Questions and answers