Challenge Titan 230 Operator's Manual page 28

6.0 Operation
using the up and down arrow keys to toggle to the desired character. The numeric keys can be used
to enter numbers directly into the job name. When the desired character is in place, use the right
arrow key to move to the next character position. The job name can be up to 10 characters long. A
letter can be removed from the job name by moving the cursor to the undesired character and
pressing the CLEAR key. When finished, press ENTER to save the name and to begin entering send
values. The screen should now look similar to the one shown next:
6.13.4.1 Entering Send Values
Now enter send values by using any of the following methods: 1) Type in the desired value and press
ENTER, 2) Press ENTER at a blank line - this will enter the current position of the backgauge as a
send value, or 3) Use the "Cut and Record" feature as described below.
When finished entering send values you may exit the current job by pressing soft-key "B" (Job) to go
back to the job mode screen or soft-key "D" (Exit) to exit to send mode. Or you may use the current
job for cutting by pressing the down arrow at the last line and following the instructions in the
"Running a Job" section (page 29).
6.13.4.2 Cut and Record
To use this feature, send the backgauge to a desired position using the backgauge glide control or by
using SEND, then make a cut. The current backgauge position will automatically be entered into the
job as a send value. This can be very convenient for setting up a program when the actual cut
positions are not known.
6.13.4.3 Channel Linking
If more than 99 cut values are needed, 2 channels can be linked together into one job providing up to
198 cut values. This is done automatically when a job is at 99 cuts and an attempt is made to add
another value. At this point, a screen is displayed asking: do you want to link to the next channel?
Use the up or down arrow key to select yes or no. If no is selected, the last cut will be discarded and
the new value will be inserted. If yes is selected, the last cut will be pushed into the first value of the
next channel, although it will be displayed as value 100 of the current channel. If the next channel is
locked, linking will not be allowed. NOTE: If the next channel is not locked, but contains data, the old
data WILL BE LOST. After 2 jobs have been linked, the linked job will be displayed as "^^^^^^^^" and
will be locked.
To unlink a job, use the up or down arrow key to point to the linked job name and press soft-key "C"
(Erase).
28
5.000
in
1> _
A) Insert C) Erase
B) Job D) Exit
# 1