Serial Command Table - RTS Cronus User Manual

Serial Command Table

Serial Command Table
TABLE 4.
Command Variable 1
set rvon
set rvon ip_addr
set rvon netmask
set rvon gateway
set rvon user
set rvon password
set rvon vad_threshold
set channel
[chan]
set channel
dest_ip
[chan]
set channel
dest_type
[chan]
set channel
chan_codec
[chan]
set channel
onhook
[chan]
set channel
offhook
[chan]
set emac auto*
set emac 10 half
set emac 10 full
set emac 100
half
set emac 100
full
set serial ip_addr
set serial baud
Variable 2
Help screen which lists all "set rvon"
commands.
X.X.X.X Set the IP Address for the RVON Card.
X.X.X.X Set network mask for the RVON Card.
Set the gateway IP Address for the RVON-8
X.X.X.X
card.
Set the RVON user name for telnet access.
abcdefg
Default "telex"
Set the RVON password for telnet access (8-40
characters).
abcdefg
Default "password"
Set the VAD threshold (silence detection)
[adaptive ⎢#]
Adaptive refers to auto-select. The # can be -20
to +10dBm.
Help screen which lists all "set tcid" commands
(TCID 0-7).
Set the destination IP Address for this particular
X.X.X.X
RVON_Channel (same as tcid).
dest_type X = 0 (rvon-8 or rvon-C), 1 (rvon-1),
X
2 (rvon-I/O).
Set the profile to use which includes the
X
compression codec see below (0-27).
Force the channel to disconnect the port.
Force the channel to connect the port.
Enables auto-negotiation of the Ethernet
interface configuration.
Configures the Ethernet interface for 10Mbps
half duplex.
Configures the Ethernet interface for 10Mbps
full duplex.
Configures the Ethernet interface for 100 Mbps
half duplex.
Configures the Ethernet interface for 100 Mbps
full duplex.
Set the destination IP Address for this serial
X.X.X.X
pass-through port.
X Set the baud rate to use: 50 through 115000.
Description
73