RVON-I/O Command Table
RVON-I/O Command Table
RVON-I/O Command Table
TABLE 7.
Command
Parameter 1
show rvon
show channel
show serial
show gpio
show panel
show emac
set rvon
set rvon
set rvon
set rvon
set rvon
set rvon
set rvon
set channel
[chan]
set channel
[chan]
set channel
[chan]
set channel
[chan]
set channel
[chan]
Parameter 2
ip_addr
netmask
gateway
user
password
vad_threshold
dest_ip
dest_type
dest_chan
chan_codec
Description
Shows RVON-I/O IP Address and other general
Shows destination address and connection
Shwos the channel control settings (poll id and
Help screen which lists all "set rvon" commands.
X.X.X.X
Set the IP Address for the RVON-I/O.
X.X.X.X
Set the Network Mask for the RVON-I/O.
X.X.X.X
Set the Gateway IP Address for the RVON-I/O.
Set the RVON-I/O user name for Telnet access.
username
Set the RVON-I/O password for Telnet access (8-
password
Set the VAD threshold (silence detection).
adaptive (#)
Adaptvie refers to autoselect. The # can be -20 to
Help screen, which lists all "set chan" commands
(0-7). This refers to VOIP channel setting.
Set the destination IP Address for this particular
X.X.X.X
X
X = 0 (rvon-8), 1 (rvon-1, 2 (rvon-I/O
Set the destination channel - the port on the far
X
Set the profile to use which includes the
X
compression codec (see page X) (0-27).
information.
information.
Shows serial port setting.
Shows gpio settings.
baud rate).
Shows Ethernet settings.
Default = telex
40 characters).
Default = password
+10 dBm.
RVON channel.
end (0-7).
27