Rvon-I/O Command Table - RTS RVON-1 Resource Manual

RVON-I/O Command Table

RVON-I/O Command Table
RVON-I/O Command Table
TABLE 9.
Command Parameter 1
show rvon
show channel
show serial
show gpio
show panel
show emac
set rvon
set rvon ip_addr
set rvon netmask
set rvon gateway
set rvon user
set rvon password
set rvon vad_threshold
set channel
[chan]
set channel
dest_ip
[chan]
set channel
dest_type
[chan]
set channel
dest_chan
[chan]
set channel
chan_codec
[chan]
set channel
input_gain
[chan]
set channel
output_gain
[chan]
Parameter 2
Shows RVON-I/O IP Address and other
general information.
Shows destination address and connection
information.
Shows serial port setting.
Shows gpio settings.
Shwos the channel control settings (poll id
and baud rate).
Shows Ethernet settings.
Help screen which lists all "set rvon"
commands.
X.X.X.X Set the IP Address for the RVON-I/O.
X.X.X.X Set the Network Mask for the RVON-I/O.
Set the Gateway IP Address for the RVON-I/
X.X.X.X
O.
Set the RVON-I/O user name for Telnet
access.
username
Default = telex
Set the RVON-I/O password for Telnet
access (8-40 characters).
password
Default = password
Set the VAD threshold (silence detection).
adaptive (#) Adaptvie refers to autoselect. The # can be -
20 to +10 dBm.
Help screen, which lists all "set chan"
commands (0-7). This refers to VOIP
channel setting.
Set the destination IP Address for this
X.X.X.X
particular RVON channel.
X X = 0 (rvon-8), 1 (rvon-1, 2 (rvon-I/O
Set the destination channel - the port on the
X
far end (0-7).
Set the profile to use which includes the
X
compression codec (see page X) (0-27).
Set the input gain for the specified channel -
X
14 to +14dB
Set the output gain for the specified channel -
X
14 to +14 dB.
Description
21