Rvon-I/O Command Table - RTS RVON-I User Manual

Digital matrix series
Hide thumbs Also See for RVON-I:
Table of Contents

Advertisement

RVON-I/O Command Table

RVON-I/O Command Table
RVON-I/O Command Table
TABLE 9.
Command
Parameter 1
show rvon
show channel
show serial
show gpio
show panel
show emac
set rvon
set rvon
ip_addr
set rvon
net mask
set rvon
gateway
set rvon
user
set rvon
password
set rvon
vad_threshold
set channel
[chan]
set channel
dest_ip
[chan]
set channel
dest_type
[chan]
set channel
dest_chan
[chan]
set channel
chan_codec
[chan]
set channel
input_gain
[chan]
set channel
output_gain
[chan]
set channel
onhook
[chan]
set channel
offhook
[chan]
set serial
set serial
mode
set serial
ip_addr
set serial
ip_addr_2
Parameter 2
Description
Shows RVON-I/O IP Address and other general
information.
Shows destination address and connection information.
Shows serial port setting.
Shows gpio settings.
Shows the channel control settings (poll id and baud
rate).
Shows Ethernet settings.
Help screen which lists all "set rvon" commands.
X.X.X.X
Set the IP Address for the RVON-I/O.
X.X.X.X
Set the Network Mask for the RVON-I/O.
X.X.X.X
Set the Gateway IP Address for the RVON-I/O.
Set the RVON-I/O user name for Telnet access.
username
Default = telex
Set the RVON-I/O password for Telnet access (8-40
characters).
password
Default = password
Set the VAD threshold (silence detection). Adaptive
adaptive (#)
refers to autoselect. The # can be -20 to +10 dBm.
Help screen, which lists all "set chan" commands (0-7).
This refers to VOIP channel setting.
Set the destination IP Address for this particular RVON
X.X.X.X
channel.
X
X = 0 (rvon-8), 1 (rvon-1, 2 (rvon-I/O
Set the destination channel - the port on the far end (0-
X
7).
Set the profile to use which includes the compression
X
codec (0-27) (see Table 11 on page 27).
Set the input gain for the specified channel -14 to
X
+14dB
Set the output gain for the specified channel -14 to +14
X
dB.
force the channel to disconnect.
force the channel to connect.
Help screen, which lists all "set serial" commands.
Set the serial mode.
X
0 = Pass Through mode
Set the destination IP Address for this serial pass-
X.X.X.X
through port.
X.X.X.X
Not Available
25

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rvon-i/o

Table of Contents